Wireless Vibration Sensor for Real-Time Vibration Data Acquision

• Customization: Available
• Type: Hall Type Speed Sensor
• Output Signal Type: Digital Type
• Production Process: Normal Wirewound
• Material: Stainless Steel
• Feature: Conductor
• IP Rating: IP68
• Certification: CE
• Customized: Customized
• Frequency Response Characteristics: 0-20kHz
• Load Capacity: Less Than 30mA
• Working Power Supply: 6V-30V
• Electrical Insulation: Shell to Ground Insulation 500VDC≥200MΩ
• Vibration Resistance: Vibration (10Hz-2kHz) 30g, Shock 200g
• Output Impedance: >47ω
• Operating Temperaturece: -40 ℃-120℃
• Transport Package: Standard Package
• Specification: Shaft diameter: Minimum: 40mm (1.6in) Recommended:
• Trademark: Tekwize
• Origin: China
• Production Capacity: 50000 Piece/Year

Product Description

The RS series Hall type speed sensor is divided into single and dual channels. This sensor has good low-frequency and high-frequency characteristics.
Low frequency can reach 0Hz and can be used for zero speed measurement of rotating machinery; The high frequency can reach up to 20KHz, which can meet the requirements of high-speed measurement. biography
The sensor is not in contact with the tested gear, with push-pull output, wide installation gap, non-destructive, easy installation, no directional requirements, and output waveform
It is a square wave with a duty cycle of about 50%, which has a simple structure, good rigidity, strong vibration resistance, and is not affected by temperature, oil, dust, etc. It is a cost-effective speed sensor



Technical Specifications
All parameters are measured at 25ºC±5ºC, with the gear module being 2, the number of teeth being 60, and the installation clearance being 1.0mm.
 

Measured sensor	If there are teeth or grooves on the magnet, it is recommended that the speed gear module be ≥1.7 and the material be magnetic low-carbon steel. Note: Non-standard teeth or grooves with different widths from the flat surface will result in a change in the waveform width ratio.
Installation clearance	0.5~2.5mm, typical value is 1.0mm, Note: depends on the vibration of the measured object.
Output waveform	Square wave, rising and falling edge time 12μs±40%	Frequency response characteristics	0~20KHz
Output amplitude	High level: <power supply, low level : <0.3V	Power polarity protection	have
Output impedance	>47Ω	Electromagnetic compatibility	CE compliant
Load capacity	<30mA	Outlet method	Aerial plug outlet & integral cable outlet
Working power supply	6V~30V	Electrical insulation	Shell to ground insulation 500VDC≥200MΩ
Transmission distance	The maximum distance between the sensor and the monitor is 500m	Vibration resistance	Vibration (10Hz~2KHz) 30g, shock 200g
Operating temperature	-40 ºC~+120ºC
Environmental protection	The protection level of the overall cable outlet meets IP67-IP68, and the protection level of the aviation plug outlet meets IP66- IP67
Material & Size	The shell and end body are made of SUS304 or SUS316L, and the shell size is 50mm to 500mm (the minimum length of the dual channel is 80mm)
Cable specifications	Three-wire twisted shielded cable, four-wire twisted shielded cable
Explosion-proof grade	Ex ia lIC T6 Ga